[Lone Sentry: www.LoneSentry.com] [Lone Sentry: Photos, Articles, and Research on the European Theater in World War II]
Photos, Articles, & Research on the European Theater in World War II
 
"How to Throw the Panzerwurfmine" from Intelligence Bulletin

[Intelligence Bulletin Cover]   A short article from the March 1945 issue of the Intelligence Bulletin with instructions for Allied soldiers on how to throw the German Panzerwurfmine, a hollow charge antitank hand grenade.

[Editor's Note: The following article is wartime information on enemy equipment published for Allied soldiers. More accurate data on German weapons and equipment is available in postwar publications.]

  
 
How to Throw the Panzerwurfmine

An antitank hand grenade has been developed by the Germans for use by infantry troops in close combat against tanks. Known as the Panzerwurfmine, this weapon is capable of penetrating 3 inches of homogeneous armor plate, and may be thrown as easily as an ordinary stick grenade.

The Panzerwurfmine, which weighs about 3 pounds, consists of a cone-shaped body with a hemispherical end, and with the stick handle attached to the other, or point, end of the cone. The most novel feature of this weapon is a set of four collapsible cloth vanes which are folded against the handle. When the grenade is thrown, the vanes spring open and presumably guide the projectile head-on to the target.

The conical head of the grenade is filled with a hollow charge designed to direct the force of explosion in one direction—against the armor plate of the target. Built to detonate on impact, the grenade fuze is located in the butt end of the hollow wooden handle, which is filled with an explosive booster charge. The fuze—a striker pin held back from a primer cap by a weak spring—detonates when the force of impact overcomes the weight of the spring and throws the striker against the cap. A safety pin which fits into the top of the fuze assembly keeps the fuze in an unarmed condition until the grenade is thrown. The fuze assembly is housed in a thin metal cylinder fitted over the end of the wooden handle.

[German Panzerwurfmine, hollow charge antitank hand grenade]
The Panzerwurfmine is a hollow charge, antitank hand grenade. When in unarmed condition, the cloth vanes, which tend to guide the projectile head-on to the target, are held folded against the grenade handle.

The grenade is armed in flight when the loosely seated safety pin is pulled free by the drag of air on a short cloth tape, one end of which is fastened to the free end of the pin.

Near the cone end of the handle, four spring steel ribs are secured in grooves. When extended, umbrella-fashion, these ribs are the framework for the cloth vanes. When the vanes are collapsed, the ribs are held under tension flat against the handle, and are secured in position by a metal cap which fits over the end of the fuze assembly and the free ends of the folded ribs. This cap is held in place by a metal tongue on the fuze assembly. The tongue passes through a slit in the cover.

During transport the tape attached to the safety pin is secured under a horseshoe-shaped metal clip which snaps around the outside of the fuze assembly, thus holding the safety pin in place. A short piece of string is tied from the clip to the end of one of the folded steel ribs.

Although the Panzerwurfmine may seem easy to use, it requires a degree of caution upon the part of the thrower, who must be sure that the vanes remain closed—thus keeping the grenade unarmed—until the weapon leaves his hand.

(1) The soldier who uses this grenade must grasp the handle in such a way that the collapsed vanes will be held closed against the handle when the retaining cover is removed. Then, and only then, can the cover be removed by straightening the metal tongue and slipping the cover free of the handle and fuze assembly.

(2) Once the cover is removed, the grenade is ready for throwing. The weapon is thrown in the same manner as the ordinary stick grenade. When the grenade leaves the thrower's hand, the steel ribs on the handle will be released from tension and snap out to extend the sail-like vanes.

(3) When released in this fashion, the rib tied to the metal clip pulls the clip clear of the fuze assembly, releasing the safety-pin tape. The drag of air on the tape pulls the safety pin free, and the striker pin is armed to detonate when the grenade strikes the target.

   [Throwing German Panzerwurfmine 1]
[Throwing German Panzerwurfmine 2]
[Throwing German Panzerwurfmine 3]
 

[Back] Back to Articles by Subject | Intel Bulletin by Issue | T&TT by Issue | Home Page


Copyright 2003-2005, LoneSentry.com. All Rights Reserved. Contact: info@lonesentry.com.  
 
Advertisement

  
Google
Web LoneSentry.com